6-4 POWER UNIT
INSTALLATION
Installation is reverse order of removal with special attention to
the following steps.
Do not re-use gasket once removed. Always use a new
gasket.
• Install two dowel pins
1, gasket 2 and intake manifold as-
sembly, then tighten bolts and nuts securely.
" Intake manifold bolt & nut :
23 N
.
m (2.3 kg-m, 16.5 lb.-ft.)
• Install fuel injectors and fuel delivery pipe. (See page 5-13)
• Check to ensure that all removed parts are back in place.
Checking
• Check fuel and water hose routing. (See page 10-8 to 10-11)
• Check wire routing. (See page 10-2 to 10-7)
• Check for fuel leakage. (See page 5-4)
• Check for water leakage.
19. Disconnect water inlet hose
K and water outlet hose L
from 3-way joint.
20. Remove nine (9) bolts and two (2) nuts and then remove
intake manifold assembly
M.
To Next Page
Loading...
