LOWER UNIT 9-9
INSPECTION
NOTE:
If excessive ware, cracks, defective or other damage is found
on any component, replace component.
NOTE:
Thoroughly wash all metal components with cleaning solvent
and dry with compressed air.
#
Wear safety grasses when using compressed air.
PROPELLER
• Inspect propeller for bent, chipped or broken blades.
Replace or repair if necessary.
• Inspect propeller bushing splines for wear or other damage.
Replace if necessary.
• Inspect propeller bushing for deterioration or slipping.
Replace if necessary.
GEARCASE
• Inspect gearcase for cracks or other damage.
Replace if necessary.
• Inspect pinion bearing for pitting, rough or other damage.
Replace if necessary.
NOTE:
If removal and replacement are required, see “PINION BEAR-
ING” section on page 9-7.
To Next Page
Loading...
