POWER TRIM AND TILT 8-7
INSPECTION
Arrange all components on a clean sheet of paper.
NOTE:
Do not lay PTT components out on a rag, as dirt or lint may be
transferred to these items which may cause possible system
operating problems.
NOTE:
If excessive wear, cracks, defective or other damage is found on
any component, replace component.
• Inspect PTT pump case for cracks, nicks, stripped threads and
any other imperfections.
Replace if necessary.
• Inspect cylinder cover for cracks, nicks or damage.
Replace if necessary.
• Inspect cylinder cover seal for cuts, nicks or wear.
• Inspect all O-rings for cuts, nicks or tears.
O-r
ingO-ring
To Next Page
Loading...
