11-20 DF140 “K2” (’02) MODEL
3. Install oil filter stand 3, then tighten filter stand to specified
torque.
" Oil filter stand: 40 N
.
m (4.0 kg-m, 29 lb-ft)
Connect inlet 4 and outlet 5 water hoses to each fitting of
engine oil cooler.
4. Screw engine oil filter 6 on by hand until the filter O-ring
contacts the mounting surface.
NOTE
Before fitting oil filter, be sure to oil O-ring.
5. Tighten the engine oil filter 3/4 turn from the point of con-
tact with the mounting surface using an oil filter wrench.
""
""
" Engine oil filter: 14 N
.
m (1.4 kg-m, 10 lb-ft), 3/4 turn
CAMSHAFT
The camshaft for DF140 was specially designed.
The height of the cam is different from DF90/115.
• Cam height
Standard:
IN. 39.520 – 39.680 mm (1.5560 – 1.5622 in.)
EX. 39.320 – 39.480 mm (1.5480 – 1.5543 in.)
Service limit:
IN. 39.420 mm (1.5520 in.)
EX. 39.220 mm (1.5441 in.)
• Camshaft identification
The camshaft is distinguished by the mark at the top of shaft.
DF140 camshaft is marked as shown.
Model Mark
DF140 3
DF115 2
DF90 1
To Next Page
Loading...
