Suzuki DF 90 Service Manual

8-4 POWER TRIM AND TILT
POWER TRIM AND TILT UNIT
REMOVAL
Raise engine to the full tilt position and lower manual tilt lock
levers 1.
#
During the following procedures, the engine must be
firmly secured and its weight fully supported. (See right)
1. Remove tilt rod snap ring 2 and push tilt cylinder upper
shaft pin 3 out.
2. Lower tilt rod to full down position and disconnect battery
cable.
3. Disconnect PTT motor cable wire leads (Green, Blue) from
PTT motor relays.
4. Remove PTT motor cable from engine lower cover.
5. Remove STBD motor mounting bolts 4 and clamp
bracket shaft nut 5.

Suzuki DF 90 Specifications

General

Steering	Remote
Starting System	Electric
Number of Cylinders	4
Trim Method	Power Trim and Tilt
Full Throttle Operating Range	5, 500 - 6, 300 rpm
Fuel System	Multi-point sequential electronic fuel injection
Ignition System	Fully-transistorized
Exhaust	Through Prop Hub Exhaust
Shaft Length	508 mm (20 in), 635 mm (25 in)
Fuel Type	Unleaded gasoline (87 octane or higher)