7-20 MID UNIT
WATER PRESSURE VALVE
REMOVAL
1. Remove PORT side lower cover. (See page 7-2)
2. Remove two bolts 1, pressure valve cover 2 and water
pressure valve 3.
INSPECTION
Inspect water pressure valve and valve cover for salt deposits,
corrosion, wear or other damage.
Clean or replace if necessary.
INSTALLATION
1. Install O-ring 1 to pressure valve cover.
2. Install pressure valve 2, and pressure valve cover 3 to oil
pan and secure with bolts.
NOTE:
Align projections on valve’s seal rubber with cutaway parts on
valve cover when installing.
Do not re-use O-ring once removed. Always use a new
O-ring.
To Next Page
