POWER TRIM AND TILT 8-11
PTT MOTOR DISASSEMBLY
1. For correct assembly, scribe an alignment mark on field case
and brush holder.
2. Remove tape from PTT motor cables and cable protector
tube, then slide cable protector tube upward.
3. Remove screw securing motor cable holder 1, then slide
motor cable holder and grommets 2 out as shown in figure.
4. Remove two screws 3 securing field case to brush holder.
5. Slide field case upward and away from brush holder.
NOTE:
When separating field case from brush holder, proceed by push-
ing PTT motor cables into brush holder side.
6. Disconnect PTT motor cables from brush holder.
7. Remove armature from field case.
Note position of O-ring encircling brush holder.
Protector
tube
1
1
2
3
To Next Page
Loading...
