REAR SUSPENSION 16-9
• Inspect the spacers and dust seals for damage.
• Inspect the bearing for excessive play and smooth movement.
BEARING REPLACEMENT
• Remove the rear shock absorber unit from the frame.
(!16-7)
• Remove the spacers.
• Remove the needle roller bearings
1.
• Remove the dust seals
2.
• Remove the needle roller bearing cage
3 with the special
tool.
# 09921-20240: Bearing remover set
• Press the bearing cage with the special tool and suitable size
socket wrench.
NOTE:
Position the bearing by refering to the illustration of page 16-22.
# 09924-84521: Bearing installer set
• Install the dust seals.
NOTE:
When installing the dust seal, the stamped mark on the dust seal
must face inside.
To Next Page
Loading...
