CYLINDER, CYLINDER HEAD AND PISTON 4-7
• Measure the piston ring free end gap.
" Piston ring free end gap
Service limit: 6.7 mm (0.26 in)
# 09900-20101: Vernier calipers
INSTALLATION
PISTON AND PISTON RING
Install the piston and piston ring in the reverse order of removal.
Pay attention to the following points:
• Apply engine oil to the piston rings and piston ring grooves.
• Fit the piston rings into the piston ring grooves so that the
each piston ring end comes to the piston ring locating pin.
• Apply engine oil to the piston pin and bearing.
• Fit the bearing to the conrod small end.
CAUTION
If the piston ring end is not at the proper position, you
can not insert the piston into the cylinder properly and
the piston ring will be damaged.
Locate the piston ring end to the locating pin and
insert the piston into the cylinder.
OK NG
To Next Page
Loading...
