7-4 MAGNETO ROTOR AND STATOR
• Remove the stator.
• Remove the key
3.
INSTALLATION
Install the stator and magneto rotor in the reverse order of
removal. Pay attention to the following points:
• Degrease the tapered portion of the crankshaft and magneto
rotor.
• Align the line on the stator and line on the crankcase to set
the ignition timing correctly.
• Tighten the stator mounting bolts to the specified torque.
# Stator mounting bolts: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
• Tighten the generator rotor nut to the specified torque with the
special tool.
# Magneto rotor nut: 55 N·m (5.5 kgf-m, 40.0 lb-ft)
" 09930-40113: Rotor holder
To Next Page
Loading...
