CLUTCH 5-7
INSTALLATION
Install the clutch assembly in the reverse order of removal. Pay
attention to the following points.
PRIMARY DRIVEN GEAR
• Apply transmission oil to the spacer
1 and needle bearing
2.
• Fit the clutch sleeve hub
3, new lock washer
4 and clutch
sleeve hub nut
5.
NOTE:
The flat side of the nut must face outside.
• Tighten the clutch sleeve hub nut with the special tool to the
specified torque.
" 09920-53740: Clutch sleeve hub holder
$ Clutch sleeve hub nut: 90 N·m (9.0 kgf-m, 65.0 lb-ft)
• Bend the lock washer
6 to secure the nut.
To Next Page
Loading...
