Suzuki RM 250 2003 - Clutch Plate; Clutch Cover

5-8 CLUTCH
CLUTCH PLATE
• Apply transmission oil to the drive plates and driven plates.
• Install the clutch drive plates and driven plates one by one
into the clutch sleeve hub in the prescribed order as show in
illustration.
• Insert the clutch push rod.
• Insert the clutch push piece and bearing. The roller side
A of
the bearing should face to the clutch push piece.
• Fit the pressure plate
1.
• Insert the springs and tighten the bolts diagonally to the spec-
ified torque.
$ Clutch spring bolt: 5 N·m (0.5 kgf-m, 3.5 lb-ft)
CLUTCH COVER
• Replace the O-ring with a new one.
Direction of outside
A No.1 drive plate B No.2 drive plate
W
Friction segment
Drive Number of
W (mm)
plate segment
A 36 8.9 (0.350 in)
B 48 6.7 (0.264 in)
Outside