8-10 TRANSMISSION AND CRANKSHAFT
BEARING INSPECTION, REMOVAL AND
INSTALLATION
• Inspect the bearings for play, discoloration, wear and seizure.
• Move the inner race by finger and inspect for smooth move-
ment.
• Remove the bearing retainers.
• Remove and install the bearings with the special tool.
" Bearing remover/installer
• Tighten the bearing retainer screws to the specified torque.
$ Bearing retainer screw: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
TOOL NO.
1
Remover 09917-50410
Installer 09913-70210
Others
Remover 09921-20240
Installer 09913-70210
To Next Page
Loading...
