CRANKCASE
When
reassembling the crankcase, pay attention to the follow-
ing points:
•
Thoroughly remove the sealant material and oil stains on the
mating surface of the right and
left
crankcases.
•
Before installing the sump
filter,
wash the sump
filter
with
cleaning solvent, and then blow compressed air through it to
dry it off.
•
Fit the O-ring into the O-ring groove as shown.
A CAUTION"
Replace
the removed O-ring with a new one to prevent
oil leakage.
•
Install the dowel pins to the
left
crankcase.
•
Apply engine oil to the conrod big end and to the transmis-
sion gears.
•
Apply grease to the lip of oil seals
®.
99000-25160: WATER
RESISTANCE
GREASE
•
Apply
SUZUKI
BOND
"1207B" to the mating surface
of
the
right
crankcase.
For
USA
4!£3 99104-31140: SUZUKI BOND "1207B"
For
the other countries
4™|
99000-31140: SUZUKI BOND "1207B"
To Next Page
Loading...
