Suzuki Vinson LT-A500F - Battery Removal; Battery Specifications; Filling Electrolyte; Initial Charging

8-28 ELECTRICAL SYSTEM
BATTERY
REMOVAL
• Remove the battery. (cCr* 7-7)
SPECIFICATIONS
Type designation
FTH16-BS-1
Capacity
12V, 50.4kC(14Ah)/10HR
® Anode plates
© Separator (fiberglass plate)
© Cathode plates
(3) Upper cover breather
® Stopper
© Filter
© Terminal
© Safety valve
INITIAL CHARGING
FILLING ELECTROLYTE
• Remove the aluminum tape © which seals the battery filler
holes ©.
* Remove the caps ® from the electrolyte container.
NOTE:
* Do not remove or pierce the sealed areas © of the electro-
lyte container.
* After completely filling the battery with electrolyte, use the
caps ® from the electrolyte container to seal the battery filler
holes.
Insert the nozzles of the electrolyte container © into the
electrolyte filler holes of the battery. Hold the electrolyte con-
tainer firmly so that it does not fall. Do not allow any of the
electrolyte to spill.