ENGINE
3-69
NEUTRAL
SWITCH
•
Install the springs
and
switch contacts.
•
Apply
THREAD LOCK SUPER
"1303"
or
"1322" to the threads
of the bolts, and then tighten them to the specified torque.
For
USA
•499
99000-32030: THREAD
LOCK SUPER
"1303"
For
the
other countries
433
99000-32110: THREAD
LOCK SUPER
"1322"
H
Neutral switch bolt:
6.5 N m (0.65
kgf-m,
4.5 Ib-ft)
CLUTCH
HOUSING
•
Install the dowel pins
and
new gasket.
•
Tighten the clutch housing case bolt to the specified torque.
H
Clutch housing
case
bolt:
11 N m (1.1
kgf-m,
8.0 Ib-ft)
MOVABLE
DRIVE/DRIVEN
FACE
AND
DRIVE
BELT
•
Insert
the
drive belt,
as
low
as
possible, between
the
mov-
able driven face while pulling
out the
driven face
to
provide
the
maximum drive belt clearance.
A CAUTION
* The drive belt should
be
installed so
that
the
arrows
on
the
drive belt periphery point
in the
normal turn-
ing direction.
*
The
drive belt contact surface
of the
driven face
should
be
thoroughly cleaned.
•
Install the movable drive face assembly.
NOTE:
Thoroughly
clean
the
drive belt contact
surface.
To Next Page
Loading...
