ENGINE COOLANT TEMPERATURE
SWITCH
REMOVAL
•
Remove
the
left
front fender side cover.
(dT
3
7-5)
•
Disconnect the engine coolant temperature switch coupler
and remove the engine coolant temperature switch.
INSPECTION
Check
the operating temperature of the engine coolant temper-
ature switch.
•
Connect the multi
circuit
tester to the engine coolant temper-
ature switch.
•
Place the engine coolant temperature switch into
a
container
of oil.
•
Heat the oil and check the temperature
on
the thermometer
when the engine coolant temperature switch is operated.
IT55LI
09900-25008:
Multi
circuit tester
set
PHBS
Engine coolant temperature switch specification
OFF
-> ON
Approximately 115°C
(239T)
ON
-»OFF
Approximately
108°C
(226°F)
INSTALLATION
Install
the
engine coolant temperature switch
in
the
reverse
order of removal. Pay attention to the following points:
•
Apply
SUZUKI
BOND
"1207B"
to
the thread portion
of
the
engine coolant temperature switch and tighten it to the spec-
ified
torque.
For
USA
4E|
99104-31140:
SUZUKI BOND "1207B"
For
the
other countries
4^1
99000-31140:
SUZUKI BOND "1207B"
H
Engine coolant temperature switch:
7.5
N m (0.75
kgf-m,
5.5 Ib-ft)
A
CAUTION
Take special care when handling
the
engine coolant
temperature switch.
Do not
subject
it to
strong blows
or allow
it to be
dropped.
•
After installing
the
engine coolant temperature switch,
be
sure to add engine coolant, (dr* 2-11)
To Next Page
Loading...
