Suzuki Vinson LT-A500F - Movable and Fixed Driven Face; Movable Driven Face Spring; O-Ring and Oil Seal

3-44 ENGINE
• Remove the movable driven face.
O-RING AND OIL SEAL
Inspect the O-rings and oil seals for wear or damage. If any
damages are found, replace the O-rings and oil seals with new
ones.
MOVABLE DRIVEN FACE SPRING
Measure the spring free length using the vernier calipers.
If the length is shorter than the service limit, replace the spring
with a new one.
Movable driven face spring free length
Service Limit: 145.4 mm (5.72 in)
MOVABLE AND FIXED DRIVEN FACE
Inspect the driven face for any abnormal condition such as
stepped wear or discoloration caused by burning. If any dam-
ages are found, replace the movable driven face with a new one.
REASSEMBLY
• Install the new O-rings.
• Apply SUZUKI SUPER GREASE "A" to the oil seal lips, O-
rings and movable driven face inside grease groove.
For USA
99000-25030: SUZUKI SUPER GREASE "A"
For the other countries
99000-25010: SUZUKI SUPER GREASE "A"