•
Install
the
movable driven face
©
onto
the
fixed driven
face
(2).
A CAUTION^
To prevent damaging the oil seal lip
from
during
installation, slide the lip using a
0.1-mm
steel sheet as
a
guide.
•
Apply SUZUKI
SUPER
GREASE
"A" to
the O-ring
and pin
hole.
For
USA
99000-25030:
SUZUKI
SUPER
GREASE
"A"
For
the other countries
99000-25010:
SUZUKI
SUPER
GREASE
"A"
•
Install the pin to the pin hole with the roller
fitted.
A CAUTION^
Before installing the pins so
that
the
flat
position (§) of
the fixed driven face threads is aligned
with
the hole
(D on the movable driven face as shown.
•
Install the movable driven face spring to the movable driven
face
by
aligning the projection
©
on the spring with the hole
@
on the movable driven face.
•
Attach the special
tool.
(j^J
09922-31430:
Clutch spring compressor
To Next Page
Loading...
