FUEL
AND LUBRICATION
SYSTEM
5-13
REASSEMBLY
Reassemble
the carburetor
in
the reverse order
of
disassem-
bly. Pay attention to the following points.
PILOT
SCREW
•
After cleaning, install the pilot screw
©
to the original setting
by turning the screw in
until
it lightly seats, and then backing
it
out the
same
number of turns counted during disassembly.
©
Pilot screw
©
Carburetor
body
A CAUTION
Replace
the removed O-ring
with
a new one.
•
Install the diaphragm.
NOTE:
When
installing the diaphragm, make
sure
the tab ® of the dia-
phragm is aligned
with
the convex section (§) of the carburetor
body's
rim.
REMOUNTING
Remount
the
carburetor assembly
in the
reverse order
of
removal. After the carburetor assembly
has
been
remounted
onto the engine perform the following adjustments:
*
Throttle cable play
2-7
*
Engine
idle speed (HT
3
2-8
To Next Page
Loading...
