Suzuki Vinson LT-A500F - Brake Pad Replacement

7-18 CHASSIS
BRAKE PAD REPLACEMENT
• Remove the front wheel, (d/
3
7-9)
• Remove the brake caliper mounting bolts © and brake pad
mounting pins (2).
• Remove the brake pads <
A CAUTION
* Do not operate the brake lever during or after brake
pad removal.
* Replace the brake pads as a set, otherwise braking
performance will be adversely affected.
• Install the new brake pads.
• Tighten the brake pad mounting pins @ and brake caliper
mounting bolts (5) to the specified torque.
H Brake pad mounting pin: 18 N m (1.8 kgf-m, 13.0 Ib-ft)
Brake caliper mounting bolt:
26 N m (2.6 kgf-m, 19.0 Ib-ft)
NOTE:
After replacing the brake pads, pump the brake lever a few
times to check for proper brake operation and then check the
brake fluid level.