Suzuki Vinson LT-A500F - Page 136

SHAFT DRIVE AND DIFFERENTIAL 4-17
Inspect the universal joint and outer surface of the bearing for
scuffing, wear and damage. If any damages are found, replace
the bearing with a new one.
DIFFERENTIAL DRIVEN BEVEL GEAR AND DIFFERENTIAL
ASSEMBLY
Check the inner race play of the bearing by hand while it is in
the differential case.
Rotate the inner race by hand to inspect for abnormal noise
and smooth rotation. If anything unusual is found, replace the
bearing with a new one.
NOTE:
Make sure to check each bearing in the same manner.
• Remove the front driven output shaft bearing using the spe-
cial tool.
09913-70210: Bearing installer set
• Remove the driven bevel gear bearing using a suitable tool.
• Remove the differential driven bevel gear housing bearing
using the special tool.
09913-70210: Bearing installer set