SHAFT
DRIVE
AND
DIFFERENTIAL
4-25
FINAL
ASSEMBLY
After
adjusting the backlash and tooth contact between the dif-
ferential
driven and drive gears and the clearance between the
driven gear
and
bearing, remove
the
differential drive gear
bearing case, differential driven bevel gear
and
differential
bevel gear housing from the differential driven bevel gear hous-
ing.
• Clean off any machinist's dye
or
paste from the gear teeth,
and lubricate the teeth
with
hypoid gear oil.
• Install new
O-rings
to
the differential driven gear bearing
case and differential drive bevel gear housing.
• Apply
SUZUKI
SUPER
GREASE
"A" to the O-rings.
For
USA
^199000-25030: SUZUKI
SUPER
GREASE
"A"
For
the other countries
99000-25010: SUZUKI
SUPER
GREASE
"A"
• Install the differential drive bevel gear housing into the differ-
ential
driven bevel gear housing.
• Tighten the differential drive bevel gear housing bolts to the
specified
torque.
H Differential drive bevel gear
housing
bolt:
23 N m (2.3 kgf-m, 16.5
Ib-ft)
To Next Page
Loading...
