Suzuki Vinson LT-A500F - Page 152

SHAFT DRIVE AND DIFFERENTIAL 4-33
BEARINGS
Check the inner race play of the bearing by hand while it is in
the case.
Rotate the inner race by hand to inspect for abnormal noise
and smooth rotation. If anything unusual is found, replace the
bearing with a new one.
NOTE:
Make sure to check each bearing in the same manner.
• Remove the bearing using the vise and attaching a suitable
tool on the drive shaft and drive gear and then tapping the
tool with a hammer.
A CAUTION
Replace the removed bearing with a new one.
Remove the final drive pilot bearing using a suitable tool.
A CAUTION
Replace the removed bearing with a new one.
• Remove the right final driven gear bearing and oil seal using
the special tool.
(^) 09913-70210: Bearing installer set
A CAUTION
Replace the removed oil seal with a new one.
• Remove the final driven gear oil seal. (CIT
3
4-34)
• Remove the final driven gear bearing using the special tool.
09913-70210: Bearing installer set
A CAUTION
Replace the removed oil seal with a new one.