Suzuki Vinson LT-A500F - Page 238

• Tighten the rear wheel set nut © to the specified torque.
H Rear wheel set nut: 50 N m (5.0 kgf-m, 36.0 Ib-ft)
• Tighten the rear hub nut © to the specified torque by apply-
ing the rear brake.
H Rear hub nut: 100 N m (10.0 kgf-m, 72.5 Ib-ft)
NOTE:
* First, remount the rear wheels and lower the jack, and then
tighten the rear axle nut to the specified torque.
* After installing the rear axle nut, insert a new cotter pin into
the axle shaft.
• After installing the rear brake, adjust the following items.
* Brake pedal play d7
=>
2-15
* Rear brake lever play Cr
3
2-15