7-66 CHASSIS
•
Install
the
range lever cable
©
into
the
cable stopper
®
located
on the
frame. Then, finger tighten
the
range lever
cable adjusting nuts
@
to hold it in place.
NOTE:
Make
sure the range lever cable is positioned so
that
the cable
stopper
® on the frame is between the range lever cable
adjusting nuts ® and washers @.
•
Turn the cable adjusting nuts
to
align the range lever cable
eye rod hole
©
with
the projection
©
on the range shift lever
arm.
•
Tighten the adjusting nuts to securely.
A
CAUTION
Make
sure to adjust the gearshift cable length prop-
erly. Improper adjustment may result in poor shifting
and damage to the cable, selection lever, or range
lever.
•
Fasten the range lever cable and range lever arm,
by
install-
ing the range shift lever cable, washer and E-ring.
NOTE:
Direction of the eye rod is determined by the side (differential
case
or crankcase
side)
it is installed on.
A
CAUTION
Be
sure to install the range lever eye rod accurately
and
that
the end face of the selection lever contacts
the flange face of the bushing © of the selection lever
cable.
NOTE:
In
handling the push-pull cable, use care not to bend it. Shown
in the illustration is a strictly prohibited example.
A
CAUTION
Do not apply a load to the end of the eye rod
with
the
cable and the metal fixture. Applying
such
a load may
cause
the sleeve to break or come off the pivot
sus-
pension.
Metal
fixture
Sleeve
Boot
LOAD
Nut
Eye rod
To Next Page
Loading...
