PERIODIC
MAINTENANCE 2-13
Remove
the movable drive face
©,
movable driven face
and drive belt
®.
INSPECTION
•
Inspect the drive belt for wear
or
damage.
If
any
damages
are found, replace the drive belt
with
a
new one.
REMOUNTING
Remount
the drive belt reverse older of removal. Pay attention
to
the following points:
•
Insert the drive belt,
as
low
as
possible, between the
mov-
able driven face to provide the maximum drive belt clearance
before installing.
•
Install the movable driven face
with
drive belt
to
the drive
shaft and temporally tighten the nut.
A CAUTION
* The drive belt should be installed so
that
the arrows
on the drive belt periphery point in the normal turn-
ing direction.
* The drive belt contact surface of the driven face
should
be thoroughly cleaned.
•
Install the movable drive face assembly.
NOTE:
Thoroughly
clean the drive belt contact
surface.
To Next Page
Loading...
