Suzuki Vinson LT-A500F - Page 58

3-18 ENGINE
• Hold the generator rotor using a 36-mm offset wrench and
then remove the generator rotor nut.
• Screw in the rotor remover attachment until the left surface
of the crankshaft seats the attachment.
IT55LI 09930-31920: Rotor remover
• Remove the generator rotor using the special tool.
09930-30721: Rotor remover
NOTE:
Do not hit the generator rotor with a hammer.
• Remove the key © starter clutch gear © and washer.
Remove the circlip, water pump drive gear and pin.