8D-4 WINDOWS, MIRRORS, SECURITY AND LOCKS
c) For vehicle equipped dead lock system:
When the driver side door key cylinder is turned LOCK
twice within 2 seconds, check all doors lock and not pulled
up all door lock knobs by hand.
If check result is not satisfied, go to “Power Door Lock System
Circuit Inspection” in this section.
Power door lock system circuit inspection
1) Disconnect negative cable at battery.
2) Disconnect door lock controller coupler (1).
3) Confirm that all doors are unlocked. Connect battery positive
and negative terminals to door lock controller coupler termi-
nals and check power door lock operation as follows.
If it does not operate as specified, repair applicable circuit or
check actuator. If it operates as specified, go to next step.
Power door lock operation for vehicle with dead lock system:
Power door lock operation for vehicle without dead lock sys-
tem:
4) Connect negative cable at battery.
\
[A] : Step 1: Lock operation check
[B] : Step 2: Dead lock operation check
[C] : Step 3: Unlock operation check
[A] : Step 1: Lock operation check
[D] : Step 2: Unlock operation check
1. Power door lock controller coupler “G02”
91011
12
13 14 15 16 17 18
1234
56 7
8
91011
12
13
14 15
16 17 18
1234 567
8
91011
12 13 14 15
16 17 18
1234 567
8
91011
12
13
14 15 16 17 18
1234
5
67
8
1
1
1
1
[A]
[B]
[C]
[D]
1
2
3
TERMINAL
G02-3G02-2G02-1 G02-10
OPERATION
UNLOCK LOCK
LOCK DEAD LOCK
DEAD LOCK UNLOCK
Step
1
2
TERMINAL
G02-3G02-2 G02-10
OPERATION
UNLOCK LOCK
LOCK UNLOCK
Step
To Next Page
Loading...
