10B-48 AIR BAG SYSTEM
DTC B1063 – Side Sensor (Driver Side) Circuit Short to Ground
DTC B1064 – Side Sensor (Driver Side) Circuit Short to Power Circuit Or Open
DTC B1065 – Side Sensor (Passenger Side) Circuit Short to Ground
DTC B1066 – Side Sensor (Passenger Side) Circuit Short to Power Circuit or
Open
WIRING DIAGRAM
DTC WILL SET WHEN
DTC B1063 or B1065 :
The voltage measured at side sensor (driver or passenger side) circuit is below a specified value for specified
time.
DTC B1064 or B1066 :
The voltage measured at side sensor (driver or passenger side) circuit is above a specified value for specified
time.
1. From main fuse 4. SDM 7. Ground for air bag system
2. Ignition switch 5. Side sensor (driver side)
3. “AIR BAG” fuse 6. Side sensor (passenger side)
GRN
BLU/RED
“G68”
“G71”
GRN/WHT
GRN/BLK
GRN/YEL
GRN/ORN
BLK
“G66”
G66-32
G66-17
G66-6
G66-16
G66-5
G66-31
1
2
3
5
6
7
4
CAUTION:
• Be sure to perform AIR BAG DIAGNOSTIC SYSTEM CHECK before starting diagnosis according to
flow table.
• When measurement of resistance or voltage is required in this table, use a specified digital multim-
eter (refer to SPECIAL TOOL in this section.) along with a correct terminal adapter from special tool
(Connector test adapter kit).
• When a check for proper connection is required, refer to INTERMITTENTS AND POOR CONNEC-
TIONS in this section.
• If there is open circuit in the air bag wire harness (in instrument panel harness), connector or termi-
nal is found damaged, replace the wire harness, connector and terminal as an assembly.
To Next Page
Loading...
