AIR BAG SYSTEM 10B-67
Handling and storage
SDM
• Never attempt disassembly of SDM.
• When storing SDM, select a place where neither high tem-
perature nor high humidity is anticipated and oil, water and
dust are kept off.
• If SDM has been dropped, replace it with a new one.
• If installation part of SDM was damaged, repair that part
completely before reinstallation.
• All SDM and mounting bracket fasteners must be carefully
torqued and the arrow must be pointed toward the front of
the vehicle to ensure proper operation of the air bag system.
WARNING:
Never power up air bag system when SDM is not rigidly
attached to the vehicle. Otherwise, personal injury may
result.
CAUTION:
After detecting one time of such collision as to meet
deployment conditions, the SDM must not be used. Refer
to “AIR BAG DIAGNOSTIC SYSTEM CHECK” when
checking the SDM.
To Next Page
Loading...
