Suzuki Wagon R RB310 - Page 216

AIR BAG SYSTEM 10B-63
Special tool
(A) : 09932-76010
(B) : 09932-75010
(C) : 09932-78310
2 1) With ignition switch OFF, disconnect Special
Tools (B) and (C) from “G69” or “G70” con-
nector.
2) Disconnect SDM connector “G66” from
SDM respectively.
3) Release shorting bar in SDM connector
inserting release tool (1) included in special
tool (A).
4) Measure voltage with connected Special
Tool (A).
• DTC B1084 : between “G66-19” terminal
and body ground, and between “G66-18”
terminal and body ground.
• DTC B1088 : between “G66-20” terminal
and body ground, and between “G66-21”
terminal and body ground.
With ignition switch ON, is voltage 0 – 1V?
Substitute a known-good
SDM and recheck.
DTC B1084 :
Repair short from “WHT/
RED” or “WHT/GRN” wire
circuit to ground.
DTC B1088 :
Repair short from “RED/
BLK” or “RED/YEL” wire
circuit to power circuit.
Step Action Yes No
[A] : Fig. for STEP 1 and 2
[B] : Fig. for STEP 2
[C] : For DTC B1084
[D] : For DTC B1088
1. Release tool
2. SDM connector “G66”
“G69”, “G70”
STEERING WHEEL
(A)
(B)
(C)
[C] [D]
[A] [B]
(A)
(A)
“G66-20”
“G660-21”
(A)
(A)
“G66-18”
“G66-19”
1
2
1
2
NOTE:
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components, ensure all components are properly mounted.
• Clear diagnostic trouble code (Refer to DTC CLEARANCE), if any.
• Repeat AIR BAG DIAGNOSTIC SYSTEM CHECK to confirm that the trouble has been corrected.