AIR BAG SYSTEM 10B-75
• Passenger air bag (inflator) module (1) (if equipped)
– Check for dents, cracks, damage or fitness.
– Check trim cover for cracks or deformities.
– Check harness and connector for damage or tightness.
If any faulty condition is found in above checks, replace.
• Air bag wire harness (1) and connections
– Check for damages, deformities or poor connections.
(Refer to “INTERMITTENTS AND POOR CONNECTIONS”
in this section.)
– Check wire harness clamps for tightness.
If any faulty condition is found, correct or replace.
• Seat belt pretensioner (1)
– Check for dents, cracks, damage or fitness
– Check harness and connector for damage or tightness.
If any faulty condition is found in above checks, replace.
• Seat belts and mounting points
– Refer to “FRONT SEAT BELT” in Section 10.
• “AIR BAG” warning lamp
– After vehicle is completely repaired, perform “AIR BAG
DIAGNOSTIC SYSTEM CHECK” in this section.
• Front seat (with side air bag (inflator) module (1) (if
equipped))
– Check front seat back for bend or damage.
– Check front seat back attachment for rattle, looseness and
damage
– Check front seat attachment for rattle, looseness and dam-
age
– Check for seat reclining and seat sliding operations
– Check wire harness and connector for damage or tightness
If any faulty condition is found in above checks, replace.
1
1
To Next Page
