AUTOMATIC TRANSMISSION (4 A/T) 7B-13
8 Automatic Transmission Basic Check and Trou-
ble Diagnosis Table
1) Check and repair according to “A/T BASIC
CHECK” and “TROUBLE DIAGNOSIS
TABLE” in this section.
Are check and repair complete?
Go to Step 11. 1) Check and repair
malfunction part(s).
2) Go to Step 11.
9 Troubleshooting for DTC
1) Check and repair according to applicable
DTC Diagnostic Flow Table.
Are check and repair complete?
10 Check for Intermittent Problems
1) Check for intermittent problems referring to
the following page.
Is there any faulty condition?
1) Repair or replace mal-
function part(s).
2) Go to Step 11.
Go to Step 11.
11 Final Confirmation Test
1) Clear DTC if any.
2) Perform final confirmation test referring to
the following page.
Is there any problem symptom, DTC or abnor-
mal condition?
Go to Step 6. End.
Step Action Yes No
To Next Page
Loading...
