Synrad FH FLYER - Tracking

tracking
SYNRAD FH Series Flyer Operator’s Manual Version 3.4
117
Use information in this chapter to setup your FH Series Flyer marking head for tracking.
The order of information presented in this section is the same as the order of tasks that
you will need to perform. The best way to get FH Flyer ready for tracking operation is to
start at Introduction and work your way through Tracking optimization. You should have al-
ready completed the steps in the Getting Started and Operation chapters of this manual.
This chapter contains the following information:
■
Introduction – describes the FH Flyer tracking function.
■
Tracking denitions – explains the denitions and terminology for tracking.
■
Tracking mark criteria – describes criteria for successful tracking operation.
■
Tracking hardware – explains how to connect position encoder, part sensor, and DC
power supply components for tracking operation.
■
WinMark Pro tracking setup – describes how to setup WinMark Pro v6 for tracking.
■
Determining line speed – illustrates how to determine line speed for your specic ap-
plication.
■
Tracking optimization – explains the concepts behind FH Flyer’s dynamic Tracker
marking and describes how to optimize tracking marks for speed and quality.
Important Note: Please review all sections in this chapter thoroughly before designing your FH Flyer
Tracker system.
Note: If you are conguring an FH Series Flyer marking head to track, please perform the tasks described
in the Getting Started and Operation chapter before proceeding with this section.
5