Synrad FH FLYER - Stand-Alone Operation

stand-alone
operation
SYNRAD FH Series Flyer Operator’s Manual Version 3.4
77
4
Use information in this chapter to congure your FH Series Flyer marking head to oper-
ate in “stand-alone” mode. In stand-alone mode, FH Flyer can operate independently of
the marking computer.
This chapter contains the following information:
■
Introduction– describes FH Flyer’s control modes and lists supported mark functions.
■
WinMark Pro/FH Flyer interface – illustrates the interface between WinMark Pro v6
and the FH Series Flyer head in stand-alone mode.
■
Conguration – explains how to setup Flyer to operate in stand-alone marking mode.