Synrad FH FLYER - Winmark Pro;Fh Flyer Interface; Version Requirements for Stand-Alone Operation; Stand-Alone Set-Up

stand-alone
operation
80
SYNRAD FH Series Flyer Operator’s Manual Version 3.4
WinMark Pro/FH Flyer interface
The WinMark Pro/FH Flyer interface section includes subsections:
Version requirements for stand-alone operation
Stand-alone set-up
Stand-alone Toolbar
Filestore structure
Fonts
Conguring a network share
Version requirements for stand-
alone operation
FH Flyer marking heads are meant for use with WinMark Pro Laser Marking Software version v5 or v6.
To verify the software build, open WinMark Pro, click the Help menu, and then choose About Synrad
WinMark… . The About Synrad WinMark dialog displays the current software version and build number.
To get FH Flyer’s rmware version, click Help and then choose About Synrad WinMark… . When the
About Synrad WinMark dialog box opens, click the Head Info button to display the “Device” tab. Scroll
down to the Marking Head Firmware Version property to view the current rmware version.
Stand-alone set-up
When communicating with an FH Flyer marking head, enter stand-alone, or FH Smart emulation mode,
from the “Device” tab (from the Tools menu, select General Settings… ). Scroll down to the Standalone
Marking property, choose “Yes”, and then click Apply. The stand-alone toolbar appears and Mark button
color changes from red to blue. Click OK to exit the General Settings dialog.
To enter stand-alone Master Control File mode, enter stand-alone mode as described above and then
locate Use Control File on the “Device” tab. Set the Use Control File property to “Yes”. Click Apply and
then click OK to save these settings. See the Conguration section later in this chapter for specic details
about operating in stand-alone or stand-alone Master Control File mode.
Note: Although entry and exit from stand-alone mode is controlled from WinMark by the Standalone
Marking property, stand-alone is a head-specic property and resides on the “Device” tab.