Synrad FH FLYER - Page 246

index
i4
SYNRAD FH Series Flyer Operator’s Manual Version 3.4
Heat load calculations A-3–A-6
I
Indicator LEDs
description, 2-2
Ethernet port, 2-2, 5-26
troubleshooting, 6-8–6-9
Initial start-up 2-3–2-7
Input circuitry. See Input/output circuitry
Input/output circuit conversion (Index/Tracker
to Flyer)
connector conversion, 5-18
input circuit conversion, 5-19
output circuit conversion, 5-19–5-20
Input/output circuit conversion (Smart to Flyer)
connector conversion, 5-22
input circuit conversion, 5-23
output circuit conversion, 5-24
Input/output circuitry
caution, 5-5, 5-8, 5-21
input circuitry, 5-7–5-13
equivalent diagram, 5-9
high/low input signal congurations, 5-13
high-speed signal parameters, 5-8
input pin assignments, 5-7
sample input circuits, 5-9–5-12
signal parameters, 5-8
input eld wiring notes, 5-8
internal +15 VDC supply, 5-7, 5-8
output circuitry, 5-14–5-17
equivalent diagram, 5-15
high/low output signal congurations,
5-17
output pin assignments, 5-14
sample output circuits, 5-15–5-16
signal parameters, 5-14
User Interface overview, 5-5–5-6
connector layout, 5-5
User Interface pin assignments,
overview, 5-5–5-6
+15 VDC, 5-7
input, 5-7
output, 5-14
Inspections
daily, 6-2
incoming, 1-4
Instructions. See Packaging instructions draw-
ings
Internal Part Trigger 4-9, 4-14, 6-15
property, 4-23
Internet interface. See Web interface
Interseg Delay 1-20
Introduction
Basic marking setup, 1-2
Tracking setup, 4-2
Inventory 1-5–1-7
Invert Encoder Direction 6-15
property, 4-23
IP address. See Ethernet IP Address or Host
Name
IP Gateway 1-21, 1-23
IP Netmask 1-21, 1-23
Isolation
USB, 1-16, 5-25
K
Keyswitch 2-4, 5-29
L
Label locations 4
Laser 1-7
mounting, 1-11
Laser Control cable 1-6, 6-14
connecting, 1-14–1-15
Laser Control connector 1-15, 2-2, 5-29
Laser Institute of America (LIA) 3
Laser Marking FAQ 3-18, 3-21, 5-5, 6-17
Laser safety information 1–3
L-bracket 1-7, 1-8, 1-10, 1-11, 1-12, A-2,
B-2, B-4, C-1, C-2, C-4
mounting, 1-9
LEDs. See Indicator LEDs
Lens
property, 2-6
Lens cleaning 6-5–6-7
Lens eld size
nominal/maximum, 5-4
Lens mount removal/replacement 6-3–6-4
Lens size
setting, 2-6, 6-13
Lens specications 5-4