Synrad FH FLYER - Page 31

getting started
SYNRAD FH Series Flyer Operator’s Manual Version 3.4
31
Use information in this chapter to prepare your FH Series Flyer marking head for opera-
tion. The order of information presented in this section is the same as the order of tasks
that you need to perform. The best way to get Flyer ready for operation is to start at
Inventory and work your way through Conguration.
This chapter contains the following information:

Introduction – explains the evolution of Flyer, illustrates the basic marking setup,
and describes Flyer’s marking and control features.

Unpacking – provides important information about unpacking your FH Series Flyer
marking head.

Inventory – describes the components shipped with your FH Series Flyer marking
head.

Mounting – describes how to mount Flyer to your SYNRAD laser and associated
components.

Cooling – lists situations that may require you to externally cool your FH Flyer head.
 Connecting – explains how to connect power, control, communication, and I/O
cabling.

Conguration – explains how to setup and congure Flyer and WinMark Pro v6 for
marking via USB or Ethernet connections.
Note:
If you are installing an FH Series Flyer head to operate in Tracking mode, please
perform the tasks described in the Getting Started and Operation chapters before
proceeding to the Tracking chapter.
1