Synrad FH FLYER - Page 9

table of contents
ix
Synrad FH Flyer Marking Head Operator’s Manual Version 3.4
List of Figures (cont.)
Figure 4-2 Usable Field Size ..................................................................................4-3
Figure 4-3 Mark Pitch greater than Usable Field Size ..................................4-4
Figure 4-4 Tracking Window .................................................................................4-5
Figure 4-5 Target Area ............................................................................................4-5
Figure 4-6 Object Reference Point .....................................................................4-6
Figure 4-7 Checking Encoder Resolution ........................................................4-7
Figure 4-8 Usable Field Size comparisons .......................................................4-8
Figure 4-9 Maximum marking position in Tracking Window ...................4-8
Figure 4-10 Wiring diagram for current-sinking (NPN open
collector) encoders .............................................................................4-10
Figure 4-11 Wiring diagram for current-sinking (NPN open
collector) encoders using Flyer’s built-in power supply .......4-10
Figure 4-12 Wiring diagram for current-sourcing (PNP open
collector) encoders .............................................................................4-11
Figure 4-13 Wiring diagram for current-sourcing (PNP open
collector) encoders using Flyer’s built-in power supply ......4-11
Figure 4-14 Linestack mark .....................................................................................4-13
Figure 4-15 Wiring diagram for current-sinking (NPN open
collector) part sensors .......................................................................4-14
Figure 4-16 Wiring diagram for current-sinking (NPN open
collector) part sensors using Flyer’s built-in power supply..4-15
Figure 4-17 Wiring diagram for current-sourcing (PNP open
collector) part sensors .......................................................................4-15
Figure 4-18 Wiring diagram for current-sourcing (PNP open
collector) sensors using Flyer’s built-in power supply ...........4-16
Figure 4-19 Part sensor setup ................................................................................. 4-17
Figure 4-20 Tracking properties on “Flyer device” tab ...................................4-19
Figure 4-21 Drawing Canvas coordinates relative to FH Flyer ....................4-20
Figure 4-22 Upstream part sensor, rising edge trigger .................................4-20
Figure 4-23 Downstream part sensor, rising edge trigger ...........................4-21
Figure 4-24 X-Y position Object Reference Point coordinates....................4-21
Figure 4-25 Part sensor output waveforms .......................................................4-22
Figure 4-26 Tracker line speed calculation #1 ..................................................4-24
Figure 4-27 Tracker line speed calculation #2 ..................................................4-25