T-Drill S-80 - Technical Features of Main Parts; Axis Directions of the Machine

INSTRUCTION MANUAL
10
3.4.1. TECHNICAL FEATURES OF MAIN PARTS

• Self-centering clamping device
• Stroke 2x65mm
• Total clamping force 14,7kN
Tool change unit :
• Programmable tool change using x,y,z movements
• Tool breakage monitoring
• Tool in posion sensors
• Chip cover for tool magazine
3.5. AXIS DIRECTIONS OF THE MACHINE
Y-
Y+
Z+
Z-
X+
X-


- Stroke +85 / - 85mm
- Speed max. 10 m/min (~166 mm/s)
- Holding brake (~40kN lin. force)

- Stroke +945 / - 45mm
- Speed max. 10 m/min (~166 mm/s)
- Holding brake (~40kN lin. force)

- Stroke 350mm (nose min. ~70mm from center)
- Speed max. 5 m/min (~83 mm/s)
- Motor brake
- Li force with nominal torque ~50kN (tool taper grip force max.18 kN)