T-Drill S-80 - Maintenance

COLLARING MACHINE
63
S-80






Maintenance intervals
Interval Maintenance Lubricant / tool Note
On every tool
change
Clean tool with a lint-
free cloth and lubricate
cone lightly
Use spray oil (Wurth
HHS 2000 or equivalent)
No regular maintenance
required
Daily
Clean all tools,
tool fastening unit,
posioning device,
spindle chuck, tool store
and guides from metal
chips and debris
Use a lint-free cloth to
clean machine surfaces
Daily
Check all tube fasteners
(tube size specic) and
tools before starng to
operate the machine
Daily
Check the condion of
all safety devices.
Daily
Check the chip tray and
oil collecng tray, and
empty when required.
Weekly
Check energy chains for
wear and tear weekly.
Use a lint-free cloth to
clean machine surfaces
1 month
Lubricate the clamping
device centering
mechanism.
Vaseline: KLÜBER
ISOFLEX TOPAS L152
(NLGI 2) or equivalent
1 month
S-80 unit inner spindle
conical roller bearings
Vaseline: KLÜBER
ISOFLEX TOPAS L152
(NLGI 2) or equivalent
2 strokes from the
grease gun
1 month
Lubricaon of the
spindle planetary gear
and needle bearing:
Vaseline: KLÜBER
ISOFLEX TOPAS L152
(NLGI 2) or equivalent
Lubricate with grease
gun: two strokes.
There are 2 grease
nipples!.