T-Drill S-80 - The Lubrication of the Collaring Process

INSTRUCTION MANUAL
48
6.4. THE LUBRICATION OF THE COLLARING PROCESS
The use of a lubricant is recommended when collaring most materials. The mist
lubricaon system consists of the lubricator and a special-made nozzle pipe.
1
2
3
The mist lubricaon system: 1. Pulse / min, 2. Oil amount regulator, 3. Air ow control

1. Fill the oil container with lubricant (Use only lubricants recommended by T-Drill).
2. Point the lubricaon nozzle so that the mist spray reaches the collaring area.
The quanty of lubricant is determined by means of the regulator. When ghtening the
regulator, the amount of oil increases and when opening it, the amount of oil decreases.
¨NOT!¨ 
lubricant before handling it.
¨NOT!¨ 
