T-Drill S-80 - Personal Protective Equipment for the Operator; General Safety Instructions

COLLARING MACHINE
7
S-80
1.4. PERSONAL PROTECTIVE EQUIPMENT FOR THE OPERATOR
Always wear the appropriate personal protecve equipment, and use extreme cauon
when operang the machine.
The local safety guidelines and regulaons are to be followed for safe operaon. The
T-Drill instrucon manual will not repeal the federal, state and local regulaons.
Use overalls when operang the machine.
2. GENERAL SAFETY INSTRUCTIONS
Read the instrucon manual aenvely before installaon, operaon or maintenance of
the machine.
The T-DRILL S-80 is to be used only for collaring in the specic way as described in this
manual.
When operang the T-DRILL S-80 it must be fastened on the oor.
Do not exceed the capacity of the machine.
Before removing or mounng a collaring head or a clamp, the electric current supply
must be disconnected by pushing the power OFF (O) buon in the front panel.
Disconnect power before carrying out any maintenance or repair inside the machine.
Do not keep any loose objects or tools on the machine.
Make sure the venlaon is sucient.
Always use protecve glasses when using the S-80 unit.
Always wear protecve gloves when handling the collaring tool.
Study also the safety data sheet concerning the lubricant which is supplied with the
machine.
When pressing the Emergency switch (STOP-buon) all funcons of the S-80 collaring
machine are immediately interrupted.
Aer installaon of the machine and before using the funcons of the S-80 collaring unit,
carry out the measures described in chapter “start-up checking”.
¨NOT!¨ 