T-Drill S-80 - Stopping the Machine; Emergency Stopping; Normal Stopping of the S-80 Unit

COLLARING MACHINE
47
S-80
6.3. STOPPING THE MACHINE
6.3.1. EMERGENCY STOPPING
In case of danger, stop the machines by pressing the EMERGENCY STOP push buon
completely down. This immediately interrupts all funcons of the S-80 unit.
¨NOT!¨ 

When the light curtain has been interrupted during the work cycle, the HOMING of all
movements has to be done in Manual screen:
Aer homing the last workpiece is removed, and a new workpiece can be placed to the
clamps and a new work cycle can be started.
When the light curtain has been interrupted during the tool change or the EMERGENCY
STOP push buon has been pushed, all movements (axis and cylinders) have to be driven
to correct posions on Manual screen.
For a controlled interrupt of the safety curtain, see 6.1.3. Control panel instrucons: Use
the “Enter the safety area request buon”.

1. Wait unl the unit has nished the automac work cycle.
2. Disconnect the main power from the main power switch (O) on the electric cabinet.
3. Close the air supply main valve on the pressure regulator.