T-Drill S-80 - Description of the User Interface Screens; Start-Up Screen

90 pages

Save Page as PDF

To Next Page

To Previous Page

INSTRUCTION MANUAL

6.2. DESCRIPTION OF THE USER INTERFACE SCREENS



When the power is switched “ON” the start screen opens to the display.

Tap the display to enter.

Main Page

Table of Contents3
Notes on the Use of the Instruction Manual5
General5
Symbols for Warning and Danger Used in this Manual5
Symbols and Warnings Used in the TCC-28 Machine6
Personal Protective Equipment for the Operator7
General Safety Instructions7
General Information on S-80 Collaring Machine8
Introduction8
The Purpose of the Machine8
Technical Specifications8
Main Parts of the Machine9
Technical Features of Main Parts10
Axis Directions of the Machine10
Transport, Handling and Location11
Transport and Location11
Lifting Instructions11
Installation12
Ambient Conditions12
Layout of the S-80 Collaring Machine13
Installation of the Light Curtains (Optional Equipment)15
Connection of the Machine to the Sources of Energy16
Connection to the Electricity Network16
Connection to the Compressed Air System17
Start-Up Checking17
The Introduction of the S-80 Collaring Machine18
Description of the Control Devices18
Main Switch18
Clamp Remote Control CB318
Control Panel19
Description of the User Interface Screens20
Start-Up Screen20
Main Screen21
Bar Charts Screen24
Menu Screen24
Programs25
Manual Screen27
Automatic Screen29
Settings Screen30
Machine Settings31
Process Settings32
Tool Settings34
Tool Magazine40
Positions42
Servo Motors43
References44
Alarms Screen45
Users Management45
Counters Screen46
I/O Data Screen46
Stopping the Machine47
Emergency Stopping47
Normal Stopping of the S-80 Unit47
The Lubrication of the Collaring Process48
Tools49
Milling Tool49
Collaring / Trimming Tool50
Collaring Tool Measuring Device 556025251
Drilling Collaring Tools54
Tool Cone Jig 656009355
Fork Tool 656009455
Reference Position Setting Tools56
Manual Feed Table57
Control Tower Signal Lights59
Operation of the S-80 Machine60
Machine General Setup60
Collaring Tool Setup60
Tool Magazine62
Maintenance63
Clamping Device Maintenance and Adjustment65
Collaring Unit Maintenance and Adjustment66
Collaring Tool Maintenance68
Dismantling and Reassembling of the Collaring Tool68
Replacing the Collaring Pins69
Smaller S-80 Heads : Fork Tool 656009471
Drilling Collaring Tool Maintenance71
Screwjack and Ball Screw Drive Maintenance77
Oil Collectors77
Spindle Lubrication Maintenance78
Troubleshooting80
Warranty83
Safety Data Regarding the Lubricants83
Ordering Spare Parts84
Appendix85
Capacity Table85
Pilot Hole Table87

T-Drill S-80 - Description of the User Interface Screens; Start-Up Screen

Table of Contents

Related product manuals