T-Drill S-80 - Page 58

INSTRUCTION MANUAL
58
1
2
3
4
5
6
7
8
9
10
1. Tube holder, 2. Locking lever for posioner, 3. Posioner (pin to hole), 4. Gas spring, 5
Li / lower locking knob, 6. Posioning plate (2 sets of holes), 7. Angle posioning plate,
8. Tube clamp operang lever, 9. Tube clamp, 10. Angle posioning knob.
To use the MFT:
Open clamp (9) by the lever (8).
Place the tube to Tube holder (1) and to the clamp (9), close the clamp.
Adjust height for the collaring of the le end of the tube: Pull knob (5) and adjust height,
the gas spring (4) will ease liing.
Adjust correct posioning plate: open locking lever (2) and pull knob (3) to adjust height.
Lock the posioner. To slide the posioner to next posioning point (hole), pull the knob
(3) and push the device to point.
Adjust correct angle: Pull knob 10 and turn the angle plate to desired angle (posioning
holes are for rotaon of 0, 5 or 50 degrees).