_Reassemble the pulley [75] and then lock it to the equipment with a strap
_Tighten the ring nut [71] on the right side of equipment. (TOOL: socket for ring nut).Then tighten
it with a torque wrench set to 100 Nm [73.8 lbf-ft] ).
_Position the belt around the pulley, rotating it.
_Adjust the belt to the correct frequency, loosening/tightening the screw [73] (TOOL: 5mm hexa-
gon key wrench).
First Installation : If the belt is replaced with a new one, tension the new belt to the frequen-
cy: 190 + 10 Hz.
If the belt is loosened / removed and then the same one is reassembled: tension the belt to the
frequency: 160 + 10 Hz
(TOOL: TEN-SIT Belt Tension Meter or EASY TENSION Application only if installed on iOS De-
vices (with externally connected microphone))
The arrow below indicates the reference of where the frequency must be measured.
TECHNOGYM ELLIPTICAL Technical Service Guide
Rev. 1.1
- 106 -
Uncontrolled copy if printed Uncontrolled copy if printed
To Next Page
Loading...
