Technogym ELLIPTICAL - Page 128

6
Lower the rear foot assembly.
Remove the screw [6] and the rela-
tive washers. (TOOL: 17mm open
end wrench).
7
Reassemble the screw [6] and re-
move the pin [7]. (TOOL: screwdriv-
er+ hammer)
During reassembly, apply
grease MOLYKOTE W2 on
the pin.
TECHNOGYM ELLIPTICAL Technical Service Guide
Rev. 1.1
- 128 -
Uncontrolled copy if printed Uncontrolled copy if printed