[3]: Turn o the equipment and disconnect the power cable from the brake board. Then insert the
tips of the tester between Phase and Neutral. Turn on the equipment and verify the Vac measured.
Fig. 33
[4]: Disconnect the cable that powers the display. Set Vdc in the tester and put the probes of the
tester in PIN 1 (red) and PIN 3 (black) of the 5x2 pin connector.
Fig. 34
TECHNOGYM ELLIPTICAL Technical Service Guide
Rev. 1.1
- 57 -
Uncontrolled copy if printed
To Next Page
Loading...
